Start with the parts that touch the drink
The Dr. Brown's Milestones Insulated Straw Cup with Handles in Green Mushrooms is built around two parts that need your attention: the soft silicone straw and the sliding lid. The straw is what your toddler sips from, and the sliding lid keeps the straw clean and liquid in the cup when not in use. Daily care starts there, not with the outer body.
Because the straw is soft silicone, it can trap residue inside the tube. Rinse it thoroughly after each use, and if you have a small straw brush, run it through the length of the straw. The sliding lid should be opened and rinsed so liquid doesn't sit in the track. These two steps do most of the work in keeping the cup ready for the next drink.
A simple daily cleaning routine
This routine follows the parts described for the Green Mushrooms cup. It does not replace any manufacturer cleaning instructions you received with the product; use those if they differ.
- 1. Separate the straw and lid: Remove the soft silicone straw and open the sliding lid fully. This exposes the areas where liquid and residue collect.
- 2. Rinse both parts right away: Run warm water through the straw and over the lid before residue dries. A quick rinse now makes the next step easier.
- 3. Wash the straw inside and out: Use a bottle brush or straw brush with dish soap. Push the brush through the full length of the silicone straw, then rinse until the water runs clear.
- 4. Clean the sliding lid track: Wipe or rinse the track where the lid slides. This is where small amounts of liquid can sit and where the lid needs to move freely to keep the straw covered.
- 5. Wash the cup body: Wash the double-wall cup body with dish soap and warm water. The double-wall construction is what keeps drinks fresh on the go, so treat the body gently and avoid submerging it if your product instructions advise against it.
- 6. Air-dry all parts fully: Shake excess water from the straw and leave every part open to air-dry completely before reassembling. A dry cup is less likely to hold odors between uses.
What the Green Mushrooms cup is designed to do
- Insulated Straw Cup with Handles, Green Mushrooms (1-Pack): Soft silicone straw teaches sipping skills. The straw is the part your toddler uses most, so keeping it clean and in good condition directly affects daily use.

Insulated Straw Cup with Handles, Green Mushrooms (1-Pack) - Insulated Straw Cup with Handles, Green Mushrooms (1-Pack): Sliding lid keeps the straw clean and liquid in the cup when not in use. The lid is a leak-prevention feature, not just a cover. Rinsing its track helps it slide properly and continue to do that job.
- Insulated Straw Cup with Handles, Green Mushrooms (1-Pack): Double-wall construction keeps drinks fresh while on the go. The insulated body is why this cup suits outings, and gentle washing helps protect that construction over time.
Leak prevention starts with the lid
The sliding lid is the cup's main defense against leaks when the cup is not in use. If you notice drips, check these points before assuming the cup is failing.
- Close the lid fully after each drink: The lid is designed to keep liquid in the cup when not in use. Slide it closed until it seats completely.
- Keep the lid track clean: Residue in the track can stop the lid from closing all the way. A quick rinse after each use prevents that buildup.
- Check the straw seating: If the straw is not pushed firmly into place, liquid can bypass it. Reseat the straw after cleaning and drying.
- Avoid overfilling: Fill only to a level that leaves room for the lid to close without forcing liquid up through the straw.
When hand washing is the safer choice
The supplied product information for this cup does not confirm dishwasher suitability. If you are unsure, hand washing is the cautious option, especially for the silicone straw and the sliding lid. Hot dishwasher cycles can also be hard on soft silicone over time, so hand washing gives you more control.
If you do use a dishwasher and your product instructions allow it, place small parts in a basket so they don't fall through the rack. But when in doubt, the sink and a straw brush are the simplest way to protect the parts that make the cup work.
Keeping the straw and lid in good shape
Small parts wear out with daily use. These checkpoints help you decide when a part needs attention.
- Straw looks cloudy or stretched: Silicone can discolour or soften over time. If the straw no longer fits snugly or looks worn, it may be time to replace it.
- Lid no longer slides smoothly: Clean the track first. If the lid still sticks or does not close fully after cleaning, the lid may need replacement.
- Persistent leaks after checking the basics: If the lid is closed, the straw is seated, and the cup is not overfilled, a worn part is the likely cause. Replacement parts are the practical next step.
What this cup does not promise
The supplied information describes a spill-proof cup with a sliding lid, but it does not list a specific age range, exact capacity, or dishwasher instructions. Those details may be printed on the product packaging or in the full instructions that come with the cup. Check those before making assumptions about fit or cleaning.
The cup is designed to keep drinks fresh on the go, but it is not a food jar or a substitute for refrigeration. Use it for drinks, and follow any age guidance that comes with your purchase.


